Ultrasound Rife Frequency Generator


Gary Wade Ultra 10-A Rife

Gary Wade is No Longer Accepting Orders for this Item - Dec. 01, 2020

We Suggest our BCX Ultra Rife as a Great Alternative

The Ultrasound 10-A Rife Generator is designed and produced by Physicist and Rife machine researcher, Gary Wade.  Mr. Wade is an internationally recognized authority on Vibrational Energy Technology and has lectured and written extensively on the subject.  He has appeared on numerous radio programs and at various alternative health therapy expos over the years.  Gary also served as the science advisor to the National Health Federation for many years.  This instrument advances the work of early 20th Century vibrational energy researchers in very important ways:

1. It is designed to produce broad-band low intensity ultrasound waves in the range from 20,000 Hz. to Tens of Millions of cycles per second. This is the same effect observed in Royal Rife's original research. The Ultra 10-A is an analog device so it does not simply produce just a progression of one frequency at a time. Rather, there are complex frequency sets and harmonics that gradually drift higher and higher over the timed period. The progression of frequencies is slow enough that it can affect the problem area with enough time exposure to have a positve result.

2. During the timed 60 minute cycle, the unit is scanning a wide range of ultrasound frequencies with complex sets of waveforms and harmonics, with no need to dial in individual frequencies or treatment codes.

As the timed cycle progresses, the simultaneously produced ultrasound frequencies generally drift upward  to higher and higher frequency values.  By the end of the 60 minute cycle, the unit has cycled through ultrasound frequencies that effectively cover from 20,000 cycles per second to Tens of Millions cycles per second. This is not a straight, linear progression of frequencies. This output contains complex internally programmed groupings of frequencies, harmonics and mixed waveforms at the proper amplitudes needed to neutralize pathogens in all of their expressed forms (virus, bacteria, yeast, fungi, parasites, etc.).

This range will effectively cover All Known Rife and Clark Frequencies
as well as targeting numerous Unknown or Potential problem areas, including viruses that mutate and change state over time.

The significance of producing broad-band, low-intensity Ultrasound Waves

Historical research in vibrational energy instruments dating from the 1920's and 1930's, suggests that apparently every microbe (single-cell organism, bacteria, fungus and virus) has at least one ultrasound frequency which can neutralize the microbe very easily.  According to Gary's research, when the energies from a Frequency Generator touch the body ( whether they apply their frequencies through pulsating light, copper rods, or stick-on electrodes) they become translated from light pulses or electrical pulses into ULTRASOUND WAVES.  These waves then travel throughout the body and when the energies resonate with the wavelength of a compatible pathogen, they tend to neutralize or disrupt the activity of that pathogen by means of vibration or oscillation. In the Ultrasound Rife Generator, the ultrasound frequencies are effectively transmitted Directly to the subject by means of a hand-held rectangular applicator that is applied onto the bare skin.  It is connected to the base unit by a length of cable.

The applicator (transducer) contains a piezo-electric wafer that rapidly expands and contracts as the applied voltage rises and falls, thus producing the ultrasound waves. Naturally, the entire process is much more compex than this brief description allows.  In any case, this method of applying broad band ultrasound is considered much more direct, efficient and effective than alternative approaches such as those using surface electrodes, metal footplates or hand-held metal rods to transfer electrical pulsed frequencies into the body. The unit is nomally applied every other day for the 60 minute timed cycle.

The Advantage of Gary Wade's Ultrasound Rife Generator over Computerized
Hand-Held or Pad Units

Today there are many so called Rife machines on the market manufactured by mainly small companies or individuals. Most of these Rife machines are voltage square wave producers that supply a constant voltage amplitude of opposite polarity (positive/negative) to two hand held electrodes or pads. The voltage polarity is reversed between the two electrodes or pads at some constant rate of reversals per second. Each disease condition and/or microbe associated with a particular disease or condition has one or more specific polarity reversal rates per second that disable it or kill it. One of the main effects of this polarity reversal at a constant rate is to produce mechanical vibrations (sound/ultrasound) in the patient of the same frequency as the polarity reversal rate. It also produces vibrations equal to odd multiples (harmonics) of the polarity reversal rate (frequency).  If the main frequency of vibration or one of the odd multiples equals or is close enough to one of the vibration frequencies that kill the microbe, then the microbe can be killed by this method. The fundamental point to understand is that every microbe that Rife worked with had at least one frequency of mechanical vibration (sound/ultrasound) that killed it very easily using very low intensity sound/ultrasound.

Today, there are fairly large lists of so-called Rife frequencies available that have been used by various voltage square wave generators which have been moderately successful in treating a long list of conditions. However, these are not in general the frequencies Rife used in destroying the microbes he worked with. There are many conditions for which these frequencies are not very effective!  In addition, there are many new or mutating pathogens for which the frequencies may not be known or published. To overcome these shortcomings, an ultrasound generation device was needed that would slowly "scan" through as much of the frequency range that Rife was known to work with as possible. The actual frequency range that Rife worked through is not really known. However, it is believed to be up to at least forty megahertz, (forty million cycles per second). By using various voltage wave form patterns applied to a piezoelectric element, it is possible to produce complex harmonic patterns (frequency sets) of ULTRASOUND. By slowly changing the frequencies of the voltage wave form patterns, the complex harmonic frequency patterns of ultrasound produced by the piezoelectric element can be slowly varied! In other words, by the "proper" choice of voltage wave form scanning patterns applied to a piezoelectric transducer element, the entire range of ultrasound used by Rife in his research can be generated! If you do not know the frequency of the ultrasound that kills the microbe it does not matter as long as you can "scan" through that ultrasound frequency at a slow enough rate and at some minimum intensity to do the job of killing or disabling that microbe! Put simply - it is efficient and easy for anyone to use!

Professional Ultrasound Generator Model 10-B

The Ultrasound Generator Model 10-B is our Professional Model that enables the operator to select individual frequencies.  In this configuration, the Ultrasound Generator is interfaced with a frequency function generator (not included with purchase).  This version is available for medical professionals who wish to extend the capabilities of the regular model 10-A and who are equipped to assist patients with potential healing reactions that can arise from concentrating on single frequencies for an entire session. We do not sell the external signal / function generator that is needed to utilize the 10-B manual frequency input. There are many companies that offer basic instruments that will work for this purpose. A basic function generator that has an output up to a few megahertz is adequate as the the 10-B unit will only amplify the input frequencies up to 400,000 cycles per second. If you need to reach higher individual frequencies above 400,000 cycles, then you can select a lower harmonic of that higher frequency on your function generator.

- this unit produces ultrasound frequencies which can tend to dissolve blood clots.  Therefore, the unit should not be used in the following circumstances:
  • Within several weeks of good healing after major or minor surgery
  • Individuals with phlebitis or anyone who has suffered a stroke caused by an artery rupturing in the brain
  • If pregnant, or suspected of being pregnant

There are numerous natural products available from major health food stores - such as EPA & DHA Fish Oils and Nattokinase that assist with a healthy circulatory system and smoothe blood flow.  Consult with your medical practitioner if you have any questions about the use of low-intensity ultrasound.

Disclaimer: Gary Wade Ultrasound Rife Generator is not a medical device.  It is an experimental electronic instrument.  It is not intended for the diagnosis, prevention, treatment, cure or mitigation of any disease in humans or animals.  It is not designed to affect the structure or function of any system in the body.  If you have a health-related condition that requires medical attention, always consult with a licensed health care professional.

at this time, all units are assembled only for U.S. 120 volts, 60 Hz.. Overseas customers with higher voltages will need to furnish their own step-down voltage transformer to use the machine. A transformer of 250 watts is good.

Shipping - free shipping in U.S. Add $60.00 shipping for Canada and $110.00 for International orders. Please note that these instruments are individually made by Gary Wade and there is a time factor of 4 to 5 weeks for assembly and delivery. So, you will need to plan ahead for this item. There are no rush orders possible.

Warranty - Transformation Technologies offers a two year warranty on your Ultra 10-A purchase. This is longer than the Manufacturer's stated warranty and applies only to units purchased directly from Transformation Technologies. This warranty will also cover the one-way cost of shipping repaired unit back to the customer.

Ultrasound Frequency Generator 10-A $2,270.00
Ultrasound Frequency Generator 10-B $2,670.00


See our Large Selection of Rife Generators


Home Page
Complete Products Listing Page with Links to All Product Pages

Sota Complete Kit - Silver Pulser SP7- Magnetic Pulser - Colloidal Silver Generator - Bio-Tuner - Lightworks - Ozone Generators - Rife Generators - BCX Ultra Rife - Gary Wade Ultra 10-A - Fscan3 - Photon Sound Beam - Life Force 2000 - Premier 2500 - Magnetic Therapy - QRS - Curatron - Infrared Therapy - Infrared Vita-Mat - Infrared Saunas - TDP Infrared Lamps - Water Ozonators - Subtle Energy Instruments -
Negative ionizers and Foot Swing Machines - Chi Machines


Ordering Ultra 10-A

We do not offer on-line ordering. Please phone, or email your order.  Assembly & ship time is normally within 4 to 5 weeks.  Free shipping for U.S., $100.00 overseas. Payment by Visa, M.C.,
Am. Ex. Discover, PayPal, check & money orders

Transformation Technologies
PO Box 4
Nobleton, FL. 34661-0004

Toll Free 1-877-287-0912 or (760) 363-5496

E-Mail  vristo@earthlink.net